Lösungen

Bore and Stroke Correct, and the Cylinder Still Will Not Fit
Replacing a cylinder sounds simple: give the bore, give the stroke. But sometimes both numbers are right, and the new unit still will not go in - the mounting holes... Mehr lesen …
Cylinder Is Home, the Sensor Light Is On, and the Machine Still Will Not Move
The cylinder extends, the position looks right, and the machine does not advance to the next step. Glancing down, the magnetic switch is lit. So what is missing? Possibly not... Mehr lesen …
Two-Position or Three-Position? What a 5-Port Valve Actually Changes
The cylinder extends and retracts fine. Now you want it to stop halfway. Looking at the selection table you see "two-position, five-port" and "three-position, five-port", and it is easy to... Mehr lesen …
Slow Cylinder? The Exhaust Silencer Is Easier to Overlook Than You Think
A cylinder that used to cycle normally starts dragging. The gauge looks fine. The speed controller has been adjusted. The speed still will not come back. Beyond checking the air... Mehr lesen …
Why an 8 mm Pneumatic Fitting Is Still Easy to Order Wrong
The tube measures 8 mm. So you order an "8 mm fitting". The tube pushes in fine - and the other end will not go into the equipment. The mistake... Mehr lesen …
Solenoid Valve Clicks but the Cylinder Does Not Move
The valve clicks. The cylinder does not move. Press start again - same result. Two conclusions get drawn at this point, and both are premature: "there was a sound, so... Mehr lesen …
Jerky Pneumatic Cylinder? Match the Symptom Before You Touch the Regulator
A cylinder that moves badly is easy to misdiagnose. Sticking at the same position every stroke, juddering the whole way, and hesitating before it lurches are three different symptoms -... Mehr lesen …
Vacuum Grippers for Robots: Six Factors That Decide the Selection
Vacuum end effectors remain the default choice for robotic pick-and-place, and the reason is structural rather than fashionable: a suction cup is simple, light, and does not mark the workpiece.... Mehr lesen …
Pneumatic Cylinder Slowing Down? A Systematic Diagnosis
A pneumatic cylinder that ran correctly yesterday and runs measurably slower today is one of the most common faults on a production machine. The instinctive response — increase the regulator... Mehr lesen …